The emitter comprises a junction box,four different colors of wires led form the function box are respectively connected with corrsponding wires on a motorcycle ,the emitter and wire connection are shown in the figure
Description of brake and steering signal receiver :1.the receiver is provided with eight high-brightness led light beads ,where in the two yellow light beads on the left are left turn lights ,the two yellow light beads on the right are right turn lights ,the four red light beads in the middle are brake signal lights2.The receiver is provided with one key switch ,particularly a on-Nigh light-off one-key switch ,when the receiver is turned on ,all the signal lights of the receiver flash twice to enter the on state ,in Night light mode,the brake signal lights flash three times quickly every 2 seconds to play the warning role during night driving ,and when the receiver is turned off ,all the singnal lights of the receiver flash once to enter off state
3.The emitter and the receiver have code matching function used when the receiver
signal lights of the receiver flash and enter the cod matching state ,press the brakelever of the motorcycle to brake ,and finish the code matching then the brake signal light on the receiver lights up
4.The receiver is powered by two 7# batteries with average service life of about one mouth ,install the batteries at the bottom of the receiver
LED WIRELESS MOTORCYCLE HELMET BRAKE & TURN SIGNAL LIGHT KIT