Welcome to ECVERY
Cree brand G2 high bright Japanese car logos lamp for JP, Toyota and son on...
Cree brand G2 high bright Japanese car logos lamp for JP, Toyota and son on...
Supplier Info
[China Supplier]
Contact Person : Ms. Liao Lily
Tel : 86-20-28294602
Fax : 86-20-28294602
Product Detail
Japanese car logos such as JP... 3W power, high bright,clear Cree brand chip LED light source length 65mm Diameter: 21mm

Cree brand G2 high bright car LED Logos with names for Japanse car logos JP and more other models 

3W power, high bright,clearCree brand chipSlim size: length 65mm  Diameter: 21mm

More funny design:

1: The Courtesy door light is specially designed for auto modification fancier, to bring more fun to drivers;

2: The dazzle logo light will display on the ground when you open the car door ,and will turn off when you close the door;

3: No pollution, no noise, no electronic interference.

4: Applicable models:

BMW, Honda, Mazda, Toyota, Lexus, Nissan, Kia, Hyundai, Volkswagen, Buick, Ford, Jeep, Porsche, Lamborghini, Ferrari, unlimited, HKS, ABT, IIIM, Harman, AMG, JP, GARSON, FOX, King Kong and so on. About 100models for your choice, Customer's logo is available.

Let me show you a kit and some detail production:

A kit include: 2pcs logo lamp, one cutter, box!

A kit as below:

Detail car model shadow picture---Lexus (taken by ourselves: daytime 10:00am!)

We do have all car models available, and some intrestring logo, OEM design welcomed!

Effect Picture:

About Installation:

This product should be installed at the bottom of the door flame and make sure the Len vertical with the ground

1.Pull down the inside door board first. Mark the suitable location for drilling a hole.

2.Drill the hole on the door board with our borer .

3.Inset the product from the bottom of car door ,then arrange the power cord.

4.Install the nut through the power cord upon the hole inside; Tighten the nut

5.Connect the power cord according to the installation guide

6.Adjust the lamp projection to the suitable place with wrench tool.

7.Reinstall the inside door board,then check the final effect.

Attention

We strongly suggest installing this product by Professional Automobile Modify Factory or Workshop. The manufacturers disclaim

all responsibility for belongings or personal casualty caused by improper installation or misuse.

Our company does not responsible for the legality of installing this product,please confirm with the vehicle management

department for the record before installation

It is better not to keep the product working more than 60 minutes to avoid damaging its lifespan

Please access the positive and negative poles of the power through voltage regulator rectifier. Do NOT direct access to car battery.

Cree brand G2 high bright Japanese car logos lamp for JP, Toyota and son on...

Ads by Google

About Us | Contact Us | Help | Terms & Conditions
Hot Products: A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z | 0-9
Copyright Notice @ 2008-2022 ECVERY Limited and/or its subsidiaries and licensors. All rights reserved.