Ads by Google
1.This bulk ink system is suitable for hp 5000/5500/5100
2.With this system, no need to buy original cartridges .The system is much cheaper than original cartridges,and easier to use . Ink can be refilled directly into tank. 3.Easy to install and use, please follow the steps: 1).Turn on the printer to examine whether the printer works properly or not, do the next step if the printer works well 2).Turn off the printer and pull out the plug of electrical power source 3).Take out the six cartridges from printer. Re: Cartridges can't be in the printer when you install this CISS. 4).Open up the device of the supplying ink of the printer.Referring to the operating method,please do it according to the original introduction of manufacturer of the printer. 5).Pull out the end of the air pressure pipe,and tie a knot on it and prick the knot tightly,then insert the end into the original place. 6).Pull out six ink pipes,and push the lock in,then pull it out.The specific methods can be seen in the production of the printer 7).Put the CISS on the printer,and connect the ink pipes to CISS pipes. Re:Connect the two pipes with a quick knot,then fill compatible inks in. 8).Install the chip decode,and then stick the data line behind the device of the supplying ink in printer into the chip decode,there is no need to stick any data line into printer yet.Please pay your attention to set the leaping cap to the correct place.The spcific introduction can be seen in the introduction of the chip decode. 9).Pump the air out from the pipe with a relative tool,then stop when you pump 50ML inks.The ink pumped out can be input into ink cartridges and be reused.And inks of the six colors should all be pumped out. 10).Screw the caps of the ink cartridges,whose caps have a hole on them.Please stuff the stoppers which filtrate the air if there are the above referred stoppers.Shut off the printer cover,and connect the electrical power source,then you can start your your printer and have a test on it.Now the fixing steps are over. RE: 1).Please turn off the electrical power source before the fixing of CISS. 2).Make sure that cartridges in printer are all pull out from the printer firstly,then fix CISS.Please pay your attention to the following things:you can't fix cartridges when you use CISS 3).The CISS only need to be connected to an ink pipe,and the air pipe should be tied a knot and pricked tightly. 4).Please fix the cartridges when you put them on the printer to avoid their falling from the printer. 5).Set the line of chip decode to the correct place.The chip decode plays an important role,so you must put it in a reliable and privy place in case that liquid flow onto it and make short circuit and destroy it.
bulk Ink system for hp 5000/5500/5100