GRE HEATER
BEEHE supplies heating blankets for GRE pipe size varying from 1 to 40 inch (25mm~1000mm).
(25-1000mm)controlled by either one or two thermostats.
blankets are divided in the following diameter ranges
1-2 inch (25-50 mm) 18-20 inch (450-500 mm)
3-4 inch (75-100 mm) 22-24 inch (550-600 mm)
6-8 inch (150-200 mm) 28-32 inch (700-800 mm)
10-12 inch (250-300 mm) 34-40 inch (850-1000 mm)
(1) Place the thermostat end against the assembled joint with the thermostat facing out from the joint.
(2) Wrap the remainder of the blanket around the joint so that any overlap will cover the thermostat.
(3) Tie the blanket in place with heat-resistant wite (copper,or soft iron)
Using the Blanket
Place the thermostat end of the heating blanket against the assembled joint with the thermostat facing out from the joint . Wrap the remainder of the blanket around the joint so that overlap ,if any,will cover the thermostat . Tie the blanket in place with any temperature resistant tie or velcro strap. Use caution when removing to avoid burns.
Insulation
It is always a good idea to insulate around the heating blanket and to close the pipe ends.This is essential when it is windy or when air temperature is below 40°F. Fiberglass insulation backed with aluminum foil generally works well. Insulation should overwrap the blanket sides about 4 inches (100mm) each way and be tied down near the deges to trap the heat.Caution :Joint must not be moved. Vibrated or otherwise distributed during cure of adhesive.
Flexible silicon rubber GRE pipe heating blanket