Embedded Optical SC fast connector for drop cable SC FAST Connector, 900um,2.0mm,3.0mm

SC fast connector

1. Put the cable through the bottom

 

.

 

2. Put the cable into the strinpping vice. The end of the cable should meet the mark. Press the handle and draw out the cable.

 

3. Put the cable into the coating stripper, the end of sleeve touch against the setting side. Close the stripper to draw out the calbe.

 

4. Put the cable in the cutting guide way, the end of the sleeve should meet the block. Cleave a 10.5mm long fiber.

 

5. Insert the fiber into the connector until the end of the sleeve meet the limiter.

 

6. Screw to close the bottom.

 

7. Press the side cover.

 

8. Take off the dust cap and clean the pin.

 

9. Put down the dust cap ant the shell.

 

A. Press the dust cap to pull out the shell.

 

B. Fit in the openner to pull out the side cover.

 

C. Take off the bottom and pull out the cable.

SC Fast Connector