Chip preparation section

Raw material is reduced into qualified chips by the drum chipper,  then the chips are transported to the chip bin, and then feed to the  knife-ring flakers by which the chips are turned to flakes, then the  flake stored in wet flake tank

Drying and sifting section

The flakes discharged from the wet flake bin are conveyed to the rotary dryer. Qualified core flakes are stored in core flake bin; oversize flakes are sending to mill to be re-crushing, and transported to surface flake bin.

Glue regulating and applying section      After scaled, the core and surface flakes are to be effectively  and uniformly mixed with qualified glue independently in their glue mixers respectively.

Forming and hot-pressing section     the surface and core flakes are sent into the forming machine and forming on the mat conveyor uniformly. After processes of metal remover, pre-press, lengthwise saw, cross saw, accelerate conveyor, scaling conveyor, storing conveyor and loading conveyor, mats are transported to carrier and then to hot press. Rough boards after pressing are pushed to unload via pallet.

Cooling and sizing section     The rough board is conveyed to star-cooler for cooling, then the rough board goes through side trimming saw and become a qualified particle-board, stacked on the hydraulic lift.

Sanding Section      The boards are sanded, classified, inspected and stored.      PLC control is used in mat-forming section.