Portable Surface Roughness Meter 1.ISO,DIN,ANSI,JIS 2.4 digits,10mm LCD,with blue backlight 3.Test Principle:Inductance type

SRT-6200 Digital  Portable Surface Roughness Meter

 

Application:

This portable surface roughness Meter is compatible with four standards of ISO, DIN, ANSI and JIS and is widely used in production site to measure surface roughness of various machinery-processed parts,calculate corresponding parameters according to selected measuring conditions and clearly display all measurement parameters.

When measuring the roughness of a surface, the sensor is placed on the surface and then uniformly slides along the surface by driving the mechanism inside the tester. The sensor gets the surface roughness by the sharp built-in probe.

This roughness causes displacement of the probe which results in change of inductive amount of induction coils so as to generate analogue signal, which is in proportion to the surface roughness at output end of phase-sensitive rectifier.

The exclusive DSP processes and calculates and then outputs the measurement results on LCD.

Feature: 

1.Very easy to operate

2.Multiple parameter measurement: Ra, Rz

3.Highly sophisticated inductance sensor

4.Built-in lithium ion rechargeable battery and control circuit with high capacity

5.Small in size, light in weight and easy to use

6.Can communicate with PC computer for statistics, printing and analysing by the optional cable and the software for RS232C interface.

 7.Manual or automatic shut down. The tester can be switched off by pressing the Power key at any time. On the other hand, the tester will power itself off about 5 minutes after the last key operation.

Specifications:

Display:4 digits, 10 mm LCD, with blue backlight

 Parameters: Ra, Rz

Display Range :Ra:0.05-10.00um/1.000-400.0uinch

                            Rz:0.020-100.0um/0.780-4000uinch

 Accuracy: Not more than10%

 Fluctuation of display value: Not more than 6%

 Sensor :

 Test Principle:Inductance type

 Radius of Probe Pin:10um

 Material of Probe Pin:Diamond

 Measurement Force of Probe: 16mN(1.6gf)

 Probe Angle: 90°

 Vertical Radius of Guiding Head: 48mm

 Maximum driving stroke:17.5mm/0.7inch

 Cutoff length (l):0.25mm / 0.8mm / 2.5mm optional

 Evaluation length: 1~5cut off optional

 Driving speed:sampling length = 0.25mm Vt=0.135mm/s

                          sampling length = 0.8mm Vt=0.5mm/s

                          sampling length = 2.5mm Vt=1mm/s

 returning Vt=1mm/s

 Resolution : 0.001μm if reading less than10μm

                      0.01μm if 10μm≤reading less than 100μm

                      0.1μm if reading ≥100μm

 Power Li-ion battery:rechargeable

 Operating conditions:Temp. 0~50°C

 Humidity <80%

 Size:140x57x48 mm (5.5x2.2x1.9 inch)

 Weight: about 420 g

 

SRT-6200 Digital Display Portable Surface Roughness Meter