Ads by Google
color changing led christmas lights
color changing led christmas lights Description:
1. SMD5050, 30pcs LEDs/meter and 60 pcs LEDs/meter LED strip.
2. Power: 36W/roll.
3. Color: RGB.
4. Waterproof: Non-waterproof(IP20), Dripping adhesive waterproof(IP65); Silicone tube waterproof(IP66); Silicone tube and Glue waterproof(IP68).
5. FPC: 8mm Width Yellow/White/Black FPC.
6. Input voltage: 12/24V DC.Controlled by remote controller for changing color mode
7. Length: 5 meter/roll.
color changing led christmas lights parameters:
| Product Name: | SMD5050 RGB LED Strip | ||
| Product Size: | 8*2.2*5000(mm) | Input Voltage: | DC 12V |
| Emitting Color: | RGB | Socket Spec.: | External power supply |
| Luminous Intensity: | 1200-1500LM | LED Quantity: | 150pcs(5meter) |
| Comsuption Power: | 36W(5meter) | ||
HUAKIA color changing led christmas lights application:
1) Architectural decorative lighting.2) Archway, canopy and bridge edge lighting. 3) Amusement park, theater and aircraft cabin mood lighting. 4) Emergency hallway lighting. 5) Auditorium walkway lighting. 6) Stairway accent lighting. 7) Concealed lighting. 8) Backlighting for signage letters. 9) Channel letter lighting. 10) Emergency exit path lighting. 11) Cove lighting. 12) Edge-lit acrylic panel lighting.
Assembly Information - Solder connection should only be performed on designated solder pads (marked “ +/-”). During? soldering, don’t exceed the maximum soldering time of 10 seconds and the maximum soldering temperature of 260 Celsius degrees.- The smallest unit (50mm or 100mm - 3 LEDs) can be removed by cutting with scissors between the designated solder pads.- The mounting of the strip is facilitated by means of the double-sided adhesive on the back-surface of the strip. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt partide. The mounting substrate must have sufficient structural integrity. Take care to completely remove the adhesive backing. Once the strip is appropriately positioned. Press on the strip with about 20N/cm2 (refer to application techniques of 3M adhesive transfer tapes).- The minimum bending radius is 2 cm. The strip may be bent over a smaller radius of the circuit board containing no electronic components and such bends should be made once and fixed in position to avoid cyclic fatigue.
color changing led christmas lights Pictures:
Application:
color changing led christmas lights