1.Furnace group 2.This type is of long life 3.Heating on the top 4.Preheat for air 5.Low consumption and burning loss

Al Fast melting Shaft furnace & Temperature-holding Furnace group

Features:

Al is melted and supplied continuously into temperature-holding furnace group. Al preheated in shaft furnace comes to the bottom of furnace and get shock heating and its temperature is close to melting point. So Al melts fast with low consumption and burning loss. This type is of long life. Compact structure: it can supply liquid Al for a few temperature-holding furnaces in the same time. Preheat for air: waste heat is used to decrease consumption or temperature of exhausted gas. Heating on the top: labor strength is decreased and operation is simply.

Specification Melting capacity for one hour: 0.1T, 0.3T, 0.5T, 0.7T, 1T, 2T, 3T, 5T

Consumption: (104 Kcal/T·Al)Furnace of 0.1T≤85, Furnace of 0.3-0.7T ≤70, Furnace of 1T ≤55, Furnace of 2-3T ≤50,Furnace of 5T ≤45, (figures indicated with continuous running).

Burning LossOriginal Al ingot ≤1.2%. when returns are 30%, ≤1.5  .  when returns are 50%, ≤2%. (figures indicated with continuous running).

Applicable Range :Continuous cast, roll, cast with low pressure and common cast of Al bar, plate and band with ingredients adjustment.

Suitable Fuels: Light oil, heavy oil, waste oil, residual oil, natural gas and various coal gas. 

Al Fast melting Shaft furnace & Temperature-holding Furnace group