Ads by Google
E3JK-5M1-N 2M Built-in Power Supply Photoelectric Sensor
DATA SHEET
Through-beam |
0 m to 15 m |
Opaque: 12 mm dia. Min. |
Emitter:3 to 15 DEGReceiver:3 to 15 DEG |
Infrared LED (870nm) |
12 to 24 VDC -10% to 10% (ripple(p-p) :10% Max.) |
Emitter: 15mA DC Max., Receiver: 20mA DC Max. |
PNP open collector output |
0 to 100 mA |
(DC) 1 V Max. (Load current: Less than 10mA)(DC) 2 V Max. (Load current: 10 to 100 mA) |
Light-ON/Dark-ON selectable |
26.4 VDC Max. |
Surge suppressorOutput short-cut protectionOutput reverce polarity protectionPower supply reverce polarity protection |
1 ms Max. |
Single-turn adjustment |
Incandescent lamp:3000 lux Max., Sunlight:10000 lux Max. |
Operating: -25 to 55 CELStorage: -40 to 70 CEL(with no icing or condensation) |
Operating: 35 to 85 %RHStorage: 35 to 95 %RH(with no condensation) |
20 M OHM Min. at 500 VDC between charged parts and the case |
1000 VAC at 50/60 Hz for 1 minute between charged parts and the case |
10 to 55 Hz, 1.5-mm double amplitude for 2 hours each in X, Y, and Z directions |
500m/s2 for 3 times each in X, Y, and Z directions |
IEC60529: IP67 |
EN60947-5-2 |
EMI: EN60947-5-2Emission Enclosure: EN55011 Group 1 classAEMS: EN60947-5-2Immunity ESD: IEC61000-4-2Immunity RF-interference: IEC61000-4-3Immunity Burst: IEC61000-4-4CE marking: Equipped |
Pre-wired models (Cable length: 0.5 m) |
Operation indicator(orange), Stability indicator(green), Power indicator(orange) |
approx. 55 g |
0.5 N.m Max. (with M3 screw) |
PBT |
Denatured polyarylate |
Instruction manual |
(4)E3JK-5M1-N 2M Built-in Power Supply Photoelectric Sensor