Vinflo mechanical cable float switch for water pump Easy to install. Available in different versions. No wear, no maintenance

Vinflo mechanical cable float switch for water pump/station

 Vinflo-06, Vinflo-13, Vinflo-20  Level Regulator

Material

Body: polypropylene

Cable: Rubber CE

Technical data

Liquid temperature:  min .0°c (32°F)

                                    max .60 °c (140°F)

Liquid density:  min. 0.95g/cm3

                           max. 1.10g/cm3

Degree of protection: IP68

USA import micro switch data

Interrupting capacity of micro switch:

AC, resistive load, 250V 10A

AC, inductive load, 250V 3A

With ENEC / VDE Certification

 The Vinflo is a build-type lever regulator for lever regulation and control of pumps and valves. 

The simplest possible method for level control! A mechanical switch in a plastic casing, freely suspended at the desired height from its own cable. When the liquid level reaches the regulator, the casing will tilt and the mechanical switch will close or break the circuit, thereby starting or stopping a pump or actuating an alarm device.

No wear, no maintenance!

In sewage pumping stations, for ground water and drainage pumping — in fact, for most level control applications — Vinflo is the ideal solution.

 

This level regulator is available in different versions, depending upon the medium in which it is to be used. As standard, the regulator can be obtained with 6 or 13 or 20 meters(20 or 42 or 65 feet) of cable for liquids with specific density between 0.95 and 1.10 g/cm3. The regulator can withstand up to 60 °c (140°F).

Example: 

Typically four regulators are used in a two pump station.

 

Vinflo mechanical cable water lever float switch for water pump