Welcome to ECVERY
Wall mouted automatic hand sanitizer dispenser KP0858
Wall mouted automatic hand sanitizer dispenser KP0858
Supplier Info
[China Supplier]
Contact Person : Ms. Zhang Becky
Tel : 86-755-29003513
Fax : 86-755-29003511
Product Detail
1.volume:800ml 2.with a tray 3.Infrared induction

Automatic hand sanitizer dispenser &inductive hand disinfect& ionautomatic induction hand disinfection machine &automatic touchless sanitizer despensor&Wall Mounted Hand Sanitizer Dispensers&alcohol hand sanitizer dispensers& automatic hand disinfector KP0858

Use 4 size D batteries.

The volume is 800 ml.        

Just move your hand in front under the dispenser’s infrared sensor and a preset amount of liquid will  spray to your hand.                                                                      

It use liquid(medicinal alcohol)

this model use partition-type sensor, Reaction is very sensitive and quick spraying directly on your skin,Completing the disinfection within 30 seconds,Killing 99.6% of the surface bacteria on your skin,Restaining sustainably the bacteria within 6 hours after disinfection,There in no undesirable side effects,Volatilization is speed,There is no need washing and drying,The effect is good,the cost is low.

Installation method:

1. Fixed hole position in the installation position,thenn drill 3 hole with the diameter of 3-6MM, then fixed the hanging panel with the plastic plugs and screws attched with the machine.

2.Aline the fixed notch of the disinfector with the installed screws,then insert the screws from down to up.

 Method of use:

1 Put 4 Size D dry batteries to the the battery box on the left side.
2Open the machine, put disinfectant into it, closed the former shell.
3Make the swich on,then put the hand within the sensor distance,the liquid will spray automatically.

This model use partition-type sensor, reaction is very sensitive and quick :Beside the nozzle;in the middle;below near the tray,which with the dark red colors,are all sensors.When you put your hand near ,or under the sensor,it can spray automatically.

4This system software, a built-in correction for long-term stable job, when the battery runs out, will slow or does not reach the designated position, you need replace batteries.
5When the red lights flashing for a long time, please replace the new battery.
6The new battery replacement method: open the battery lid, hand battery replacement battery box, pull out a new battery, the battery using 1rd.
7Put the key on the cover lock, counter-clockwise, then lock body, vice verse can open it.

 Technical parameters:

Voltage: 6V DC voltage

Capacity: 800ML

Induction distance: 3-15CM

Fluid volume: 1-2ML/times

Wall mouted automatic hand sanitizer dispenser KP0858

Ads by Google

About Us | Contact Us | Help | Terms & Conditions
Hot Products: A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z | 0-9
Copyright Notice @ 2008-2022 ECVERY Limited and/or its subsidiaries and licensors. All rights reserved.