Digital stepping motor driver using new 32-bit DSP with high performance, low power consumption, high torque, and low noise, High Quality China Digital stepping motor driver using new 32-bit DSP with high performance, low power consumption, high torque, and low noise Suppliers and Manufacturers

Digital stepping motor driver using new 32-bit DSP with high performance, low power consumption, high torque, and low noise

Supplier Info

Changzhou Dewo International Trade Co., Ltd.

[China Supplier]

Contact Person : Ms. Jin Liying

Tel : 86-0519-88996960

Fax : 0519-88996960

Product Detail

High performace,low power consumption,High microstep,high torque,low noise,broad voltae range,

DW230 Characteristics:

1.DC power input type24V~36V2.Output current:0.9~3A3.Mircostep:1(1.8º),1/2,1/4,1/8,1/16,1/32,1/644.Protect form : Overheated protect, lock automatic half current ,error connect protect 5.Dimension:115mm*72mm*32mm6.Weight:<300g.7.Working environment:Temperature-15~40°C Humidity<90%.

I/O PORTS1,VCC+:DC power positive poleNote:Must guard against exceeding 40V, so as not to damage the module2,GND:DC power cathode3,A+,A-:Stepping motor one winding 4,B+,B-:Stepping motor other winding5,CP +,CP -:Stepping pulse input+5V (Rising edge effective , rising edge duration >10μS)6,CW +,CW-:Stepping motor direction input, voltage level touched off,high towards, low reverse7,REST+,REST-: motor free The interface see the right picture

NOTE:1, When ambient temperature is high or working current over 2A, fix the module on big metal shell , or use axle flows fan dispels the heat, to make the module run reliably for a long time. 2, Half current automatically: if control machine not send out signal in half second, driver enter half current state of automatically for electricity saving, the phase current of the winding of the electric3, The fault phase is protected : When the double-phase electrical machinery is connected with driver , users are apt to connect the phase by mistake, thus would damage the driver seriously. The protecting circuit is within this driver, when users connect by mistake, the driver will not be damaged, but the electrical machinery runs abnormally, shake , and output is small. Please check whether the wiring of electrical machinery is a mistake

Switch Choice: (“ON=0,OFF=1”)

1,Microstep choice

M1	1	0	1	0	1	0	1	0
M2	1	1	0	0	1	1	0	0
M3	1	1	1	1	0	0	0	0
Micro	1	1/2	1/4	1/8	1/16	1/32	1/64	____

2,Current choice:

M5	0	0	0	0	1	1	1	1
M6	0	0	1	1	0	0	1	1
M7	0	1	0	1	0	1	0	1
Current(A)	0.9	1.2	1.5	1.8	2.1	2.4	2.7	3

Digital stepping motor driver using new 32-bit DSP with high performance, low power consumption, high torque, and low noise