AAC Technological Flow of Production of Autoclave Aerated Concrete

1.        First,dose and match measured raw materials;

2.        After distributing,feed raw material into pouring mixer to make slurry;

3.        Through thoroughly mixing,theslurry is poured to mould;

4.        After pre-curing under a certain temperature and time, the block would reach a certain hardness prepare for cutting;

5.        Tilting hoister would ture over 90 degrees of mould.

6.        Then open the mould and scparete it from block.And take the block with side plante to the cutting cart;

7.        The blocks then be cut throught the cutter firstly of two vertical sides of block;

8.        Secondly the horizontal cutting;

9.        Finally the vertical cutting;

10.  After cutting,the block is hanged to trolley with side plate by semi-finished product hoister;

11.  Organizing the cut blocks and put them into autoclave;

12.  Hardeening the block under certain temperature and pressure;

13.  Take finished products out of autoclave;

14.  The finished product hoister take the finished product to stock shield;

15.  Packed for loading;

16.  The side plate return back by side plate roller;

17.  Side plate would be organized with open mould;

18.  Clean the mould and preparing for next pouring;

19.  Steel bars processing line for slab production.

AAC 4300 x 1500 x 650 mm Mould AAC brick making machine