Welcome to ECVERY
2012 plastic PVC PPR pipe fitting mould
2012 plastic PVC PPR pipe fitting mould
Supplier Info
[China Supplier]
Contact Person : Ms. Yu Sulan
Tel : 86-576-84116950
Fax : 86-576-84360661
Product Detail
2012 plastic pipe fitting mould Stainless steel material 15mm-500mm diameter Automatical production 500k shots guarantee

2012 plastic pipe fitting mould

The hardness of slider is more than 50 HRC

1. High-quality steel to be recommended in accordance with the plastic material of the injected part.

2. Steel hardened to be more than 40HRC to get longer mould life.

3. Quality spare parts to be used to guarantee the mould life.

4. Quality hot runner to be used to reduce cycle times and maintaining the consistency during continuous


5. Our products are widely recognized and trusted by users and can meet continuously developing economic

and social needs.

1.About designAdvanced structure is designed to improve rate of finished products;

 Two-step double taper locating technology;

each cavity self locked independently;

off-center adjustment system make the thickness error of perform less then0.05mm.

Bottleneck is adopted International Screw thread standard, No cutting of gate to reduce the labor intensity


2. Material of steelcavity and core use imported S136 stainless steel with fine polishing, high hardness to get mold's high precision and good quality.

------------------------------------------------------------------------------------------------------------------------------3.About gate pin-valve gate ,pneumatic drive the nozzle pin simultaneous high speed open and close action. which can effectively control the injection hole open and close actions on each cavity. reliable seal function, smooth moving, low thermal expansion rate ,long using life and also saves electric energy.


4.About hot runner hot runner system is designed and made by ourselves, it can achieve ideal and prompt heating effect for preform production ,cavity with lower injection pressure to reduce wear and tear of mould parts.


5.heat system with double heating system,it has separate temperature control mode ,the heat bar are used to heat the mould mainfold plate,small heaters supply the heating temperature for cavity nozzle continuously.

------------------------------------------------------------------------------------------------------------------------------6.cooling system each parts including core ,cavity and valve gate has independently cooling system.


7.heat treatment mechanical treatment cavity and core to prolong service life ,nitrogen treatment with neck screw.with fitly operation ,guarantee Long using life over 2.0 million shots of injection cycle


8.special satisfied serviveeach mould undergoes strict mould test before delivery.we can provide an experienced team for installation and test as per client's request Standard inter-changeable mould components


9. all the  parts of moud use standard parts. can  Interchangeable between same kind moulds


           Mould base


           Runner Type

hot/cold runner


wooden case and auti-rust paint outside


high polish and good surface


high quality as the customers's required

           Processing time

45-50 days

           Delivery time

45-60 days


Processing Site:


Mould Manufacture Process:

2012 plastic PVC PPR pipe fitting mould

Ads by Google

About Us | Contact Us | Help | Terms & Conditions
Hot Products: A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z | 0-9
Copyright Notice @ 2008-2013 ECVERY Limited and/or its subsidiaries and licensors. All rights reserved.