EOC CLAMP NUT
1.Material:spring steel
2.Specification: EOC25 / EOC32
Mounting instruction for EOC collet and nut
1.Put the collet into the nut in level direction,push in into the nut
2.Fix the nut and the collet on the spindle rotate the nut until the collet is pressing.Wipe the straight shank of cutter,and insert it into the pilot hole.Tighten the nut with a wrench till the cutter is clamped heavily
(Caution:never tighten the nut without cutter in it for it will break)
3.When changing the tool,loosen the nut and it shall bring out the collet and the cutter together,and then drawthe cutter out push out slightly the collet in the offered direction,it shall be ready for any change of the cutter.
EOC CLAMP NUT