Welcome to ECVERY
Automatic door remote control switch
Automatic door remote control switch
Supplier Info
[China Supplier]
Contact Person : Mr. Wang Frank
Tel : 0086-21-51870528
Fax : 0086-21-39650007
Product Detail
Automatic door remote control switch.

Hopping Code Automatic Door Remote Control Switch & Timing Module

Wafer use *frequency spectrum ranges between 300-500 MHz and most of the transmitter/receivers rely on hopping or rolling code technology. This approach prevents perpetrators from recording a code and replaying it to open a garage door or automatic sliding door. Since the signal is supposed to be significantly different from that of any other garage door remote control, WAFER claim it is impossible for someone other than the owner of the remote to open the door. When the transmitter sends a code, it generates a new code using an encoder. The receiver, after receiving a correct code, uses the same encoder with the same original seed to generate a new code that it will not be accepted in the next time.

Description Specification
Frequency 433MHz/315MHz (Optional)
Input Voltage (Receiver) 12 to 24V AC/DC
Code Type Rolling Code /Hopping Code
Max.Number Of Transmitters to be Programmed to One receiver 15 Transmitters
Operating Temperature -10 to 60

Dimensions (L x W x H) (Receiver)

98mm x 52mm x 27mm

********** DIP SWITCH FUNCTION ********** Dip Switch1:

Model#ABOperating Mode
1OFFOFFNormal Receiver (Factory Setting) (No Delay Output)
2ONOFFReceiver with Time Delayed Output
3OFFONSensor or Switch Mode
4ONONBACK

Dip Switch2 ( Time Delayed Output Setup (only with sensor mode) ):

Model#CDTime Delay
1OFFOFF5 Seconds
2ONOFF10 Seconds
3OFFON15 Seconds
4ONON20 Seconds

Automatic door remote control switch

Ads by Google

About Us | Contact Us | Help | Terms & Conditions
Hot Products: A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z | 0-9
Copyright Notice @ 2008-2022 ECVERY Limited and/or its subsidiaries and licensors. All rights reserved.