Ads by Google
Feature:
Type: Receiver module with decode for fixed codeModulation Method: Amplitude modulation (OOK)Working Voltage: DC 9 ~ 12VWorking Current: 5~8mARF Sensitivity: -103dBmCoding Method: Learning fixed codeDecoding Outputs: Low levelWorking Temperature: -20°C ~ +70°CSize: 40x39x17mmWith 12 decoding outputsFour Control Modes: Toggle, Momentary, Latched, Toggle + MomentaryFrequency: We can offer 315 MHz or 433.92 MHz, you can choose one.Application:
The RF receiver modules are widely used for remote controls, remote control toys, anti-theft alarms, garage doors, roller shutter, road barrier, retractable doors and so on.Notes:
It is best to use the antenna of 1/4 wavelength, for antenna has a great impact on receiving effect of the module; normally using 50Ω single core cable. For frequency 315MHz, the length of antenna is about 23cm; for 433MHz, it is about 17cm. The position of antenna also affects the receiving effect of the module. When installing the antenna should be extended as much as possible and be away from the shield and the place in high pressure and interference.The receiving frequency, decoding mode and timing resister should be compatible with the transmitter.Setting different control modes:
Learning method of control mode Latched: When the receiver is in the status of LEARNING, press button 1 of the remote control.Control mode Latched (output 1~12): Press -> On, other outputs Off; Press other button -> Off.Outputs 1~4 are interlocked; Outputs 5~8 are interlocked; Outputs 9~12 are interlocked.Learning method of control mode Momentary: When the receiver in the status of LEARNING, press button 2 of the remote control.Control mode Momentary (output 1~12): Press and hold -> On; Release -> Off.Learning method of control mode Toggle: When the receiver is in the status of LEARNING, press button 4 of the remote control.Control mode Toggle (output 1~12): Press -> On; Press again -> Off.Learning method of control mode Toggle + Momentary: When the receiver in the status of LEARNING, press button 8 of the remote control. Control mode Momentary (output 1~6): Press and hold -> On; Release -> Off.Control mode Toggle (output 7~12): Press -> On; Press again -> Off.Introduction of pin (from left to right)
Pins | Function |
D0~D11 | Data output |
VCC | Positive power supply |
GND | Negative power supply |
12 CH Super Regeneration RF Relay Module Receiver Modules for Remote Control DC 9 ~ 12V