pressure sensitive foam tape designed with a unique, stretchable backing which allows clean, damage-free removal from most fac

Physical Properties  Adhesive Type  Rubber

Not for specification purposes  

Foam Type  Polyethylene

Adhesive Family  710 (R-10)

Thickness (ASTM D-3652)  

Nominal  0.042 in. (1.1 mm)

Tolerance  0.030 0.054 in.

Release Liner  0.003 in. (0.08 mm) Red / Black Printed Paper

Colour  White

Approximate Density :  

Lb./ft.3   12

Foam Only (kg/cm3)  (192)

Shelf Life  36 months from date of despatch  when stored in the

original carton at 21°C (70°F) & 50 % Relative Humidity

  

As shown on above table, greater weights can be supported if the load is applied after

one hour adhesion build time.   

1.a utility hook is adhered to a wall but nothing is hung from the hook for one

hour.  The hook can then hold a greater weight than if something had been hung from it

immediately.

2. adhesive has good adhesion to most painted surfaces as well as to low

surface energy plastics such as polypropylene and polystyrene while maintaining

excellent adhesion to metals, glass and high surface energy plastics.

adhesive will reach maximum adhesion in one hour. Adhesion to polyethylene will

usually be dependent on special surface treatment. Because of additives in plastics

and high solid paints, it is important for the user to evaluate individual applications for

appropriate use and suitability.

 3.Care should be used when bonding to surfaces with very low internal strength such as

painted plaster board, fabric or cloth, wallpaper, blown vinyl etc since delamination

of that surface may occur.

removable foam tape