Ads by Google
MRK-3 Marble crystal powder
1.Amount:First add 2 powder into the bottle and then add 1 water. Tight the cover and shake to evenly.2.Applications:Pre-wet the surface first, in the 3-5 square meters of ground covered with batter in parallel, according to the type and tightness of stone,put the batter 30-40 ml per square meter, immediately use a low-speed single-wipe machine which a white scouring pad with to grind all the batter,(5-6 minutes per square grinding). Careful not to allow slurry to dry! Ddd water to dilute the slurry, to stop the crystallization. Then use the suction machine to draw slurry, and through the water with plenty of water . After crystallization, clean the surface with mild detergent.
Instructions:Clean the stone surface thoroughly,remove the old wax,mix the crystal powder with water to soupy states,then take the right amount of the product and put it under the polishing mat.During grinding process,add slight of water and keep wet grinding consistently,grind the surface repeatedly according to different stone material and its degree of wear until the stone surface creats gloss crystal layer.Use vacuum clearner absorb the remnant soupy things.Finally changed the fur polishing mat to do fine grinding,and the stone shine like new.
Working area:100-200m2/kg.
Time keeping:2-12months according to hardness of stone and visitors flow rate.
Packing:2kg or 5kg per barrel.
Storage:save in the dry place.Save Period:2years.
Warning:It is harmful when breathing in,skin exposure or deglutition.In case of contact with eyes,please wash with plenty of water,seek medical assistance immediately.
HOW TO USE MARBLE CRYSTALIZER :
1. sweep the floor to remove loose floor debris.
2. Make sure that the floor is free from wax and dirt by stripping it with a wax stripper solution and black stripping pad.
3. Rinse or damp mop the floor with clean water thoroughkly ,making sure there is no residueof stripper solution left on the floor .
4. On a two (2) to three (3) square meter area,spread 2 to 4 tablespoonfuls of powder and 150 to 250 ml of water directly on the marble floor .
5. Place a low speed (175to 300rpm) floor polisher with red polishing pad on top of the marble crystalizer powder and buff the floor .
6. Do not allow the solution to dry .keep it wet by adding 100 to 150ml water regularly.
7. Using a floor squeegee ,inspect the area being crystallized after 4 to 5 minutes and check if the marble has reacted already.
8. If the marble exhibits a wet look gloss already ,transfer the used solution on adjacent untreated area by using the floor squeegee.
9. Rinse the finished area well with mop and clean water .
10.To maximize the product ,re-use the solution from step 8 for a few more minutes on the adjacent untreated area before picking it up with a wet vaccum or mop .place new marble crystalizer and water on this area and repeat steps 4to 10.
11.After the entire floor has been crystallied ,damp mop or scrub the floor (with a clean red pad)and clean water .let dry .
12.Remove the remaining marble crystalizer powder residue from the floor by dry buffing the floor .
13.This is done by placing a thick ,round circular cloth under the polisher and dry buff ing the entire area.
....
Marble crystal powder