Q-SCD200/DL30A,the equipment for bridge's maintenance and repair, can be used for the bridge's pier.

.  The maintenance and repairment of all kinds of cable-stayed bridges upper-anchor and the main bridge can be realized through model Q-SCD200/DL30A product. In this equipment, lift system should be installed in outside or inside of the cable-stayed bridge, which can be the work platform to maintain the main bridge and upper-anchor and adjusts the main bridge and upper-anchor. The work platform can up, down or stop to any point of the main bridge so that the staff can work conveniently.

The following is this products parameters:   

Items	Units	Parameters
Rated load	kg	300
Operation speed	m/min	9.3
Detection of cables diameter		(according to you situation)
Tilt angle of cable-stayed	degree	20 -- 80
Distance of remote control	m	120
Effective drive	G	115(It can work 100 hours)
Temperature of applicable environment		-20 --- +40
Wind speed	m/s	≤10.8(6 wind)
Relative humidity		≤90%(25)
Electrical power	KW	2×2.2
Braking torque	N.M	2×15
Rated upgrading power	KN	2×7.85
Rated voltage	V	AC380±5%
Weight of maintenance equipment	kg	470
Weight of the whole machine	kg	1000
The minimum braking rally to tracing wire-rope	KN	2×68.5
Size of frame(length×width×height)	mm	2000×1000×1720

 Note:   this equipment has no standard provision. We will design the product according to your situation. The distance of the remote control, the tilt angle of the cable, the diameter of the cable, applicable environment, and so on, all of above will decide the size of the product you ordered. So, before ordering the product, please communicate with us so that we can provide the most accurate size product to you.

equipment for bridge's maintenance and repair