Ads by Google
LED RGB controller with touchable button
Product Brief
VE-CON-001X it’s dedicated to control overall RGB color changes of full color LED lights with 4-wires, 3 channels (common anode), such as RGB LED module, LED strip, LED flexible tape, and other LED lights.
1. Technical Specs:
Model VE-CON-001X | |||
Input Voltage | DC12V | Wireless mode | touchable/RF |
Loadable Current | Max5A×3 | Output Power | 180W |
Color Modes | 15 modes | Grey Steps | 256 steps per RGB |
Remoter material | ABS+PC | Remoter Size | L113.5×W55×H21(mm) |
Intensity Steps | 8 Steps | Controller size | L85×W65×H24(mm) |
Working Temp | -35°C-55°C | Packing Size | L120×W72×H50(mm) |
Controllable Distance | Max 20M | Gross Weight | 150g |
Accessories | 3 pcs AAA batteries | Power Amplifier | Compatible with our power repeater |
1 | Auto color changing | 8 grades of brightness to adjust by pressing Key 4 or Key 5. | |||
2 | three colors jumps to change | 8 grades of speed to adjust by pressing Key 4 or Key 5 | 9 | Gree color jumps to change | 8 grades of brightness to adjust by pressing Key 4 or Key 5. |
3 | seven colors jumps to change | 10 | Yellow color jumps to change | ||
4 | three colors jumps to gradual change | 11 | Cyan color jumps to change | ||
5 | seven colors jumps to gradual change | 12 | white color jumps to change | ||
6 | red color jumps to change | 8 grades of brightness to adjust by pressing Key 4 or Key 5. | 13 | Red/blue light twinkles alternately | 8 grades of speed to adjust by pressing Key 4 or Key 5. |
7 | Blue color jumps to change | 14 | Green/blue light twinkles alternately | ||
8 | Purple color jumps to change | 15 | Red/green light twinkles alternately | ||
2.Product Picture
1. Remoter and sketch diagram
2. Controller picture and Sketch Diagram
3.Remoter back and battery:
4 Connected to LED RGB module;
3.Exception Handles
Malfunction | Causation | Settle |
No light | 1. No power; 2. The protection of the power supply is active; 3. Wrong connection | 1. Check the power 2. Check the fault, then power on again; 3. Check the connection |
Incorrect color Amplifier not in phase | 4. Wrong connection from RGB wire 5. In-phase cable connected wrong | 4. Re-connect RGB wires correspondently 5. Re-connect in-phase wires correspondently |
No response from the remoter | 6. Wrong battery installation; 7. Beyond controllable distance | 6. Install the battery correctly; 7. Reduce remote controllable distance; |
Delay response from the remoter | 8. battery power is not enough; | 8. Replace battery; |
Uneven intensity between front and rear, with voltage drop | 9. Output cable is too long 10. Wire diameter is too small 11. Overload beyond controller or power supply capability | 9. Reduce cable or use loop supply. 10. Change wider wire 10. add power amplifier |
Signal chaos between controller and remoter | 12. Controlled may be controlled by other remoters; | 12. Clear the memory as the No. 3 and No.1(See Matching of controller and remoter) |
Touching RGB controller