Plate induction heating machine

Heat or make heat treatment of the plate, the most important issue is to ensure uniformity of heating, followed is impedance matching to ensure that the rated power output, for the non-magnetic stainless steel plate and aluminum plate, require induction heating machine with higher output frequency (generally more than 20KHz), and output higher current density on the inductor, to achieve the purpose of heating the plate. AtecD series of high-frequency induction heating machine, use of special plate heat inductors, not only the heating uniformity is good, but easy to install. Through the specific impedance matching, can do continuous heating for any kinds of plates. M-Series High Frequency up to 100KHz, can be used for heating small workpiece. All air  cooled structures, systems with high efficiency, fast heating aluminum.

IGBT inverter, efficiency and power factor are high. System failure rate is low, the device has no water system failure. Built-in temperature PID procedures, can realize constant temperature heating.

A variety of control methods and a rich interface, easy to implement automatic control. Precise control of the DSP, the frequency of automatic tracking, ensure that devices work in the best resonant state; and if the grid voltage fluctuated, the output power will remain unchanged. Fully functional and reliable protection limit, short circuit in the sensor, workpiece short-circuit, overload operation, abnormal fluctuations of the grid, the equipment will not be damaged. Output transformer isolation, the sensor voltage is low, and can be single-grounded. Air-cooled transformer design life of 10 years, no brass jams. No polarity filter capacitor design life of 10 years (electrolytic capacitors less than 5 years). The parameter setting functions online. 

Plate induction heating machine