Welcome to ECVERY
Hydraulic Pipe End Clamping Machine
Hydraulic Pipe End Clamping Machine
Supplier Info
[China Supplier]
Contact Person : Mr. Wu Fisher
Tel : 86-351-2021485,15203433765
Fax : 86-351-4062283
Product Detail
1. Automatic operation; 2. Short pieriod; 3. Low investment.


Sink tube end with a good consistency to improve the yield;Sink tube end looks like the neck of a bottle, with a smooth surface; meanwhile, the slope part can be drawn without leaving 20mm-30mm during crop end;Due to a hole exists in the tube head, it is hard to break off during drawing a pipe after acid pickling and phosphating;An adjustable sink tube end could be achieved to save in material;The round mouth of tongs well matched with a round tube end to produce force within reason during cold drawn; such device with a high bearing capacity;Not only suit for hot shell pipe, but also for cold pipe of 4-5mm;Only 3-5 seconds to sink a tube end;

All above mentioned speak of a higher yield, about 1%, to reduce the industry cost. It is also a developed regeneration product of air hammer and hydraulic crimping machine which are widely used in seamless pipe industries.

Hydraulic Pipe End Clamping Machine

Related Products
Ads by Google

About Us | Contact Us | Help | Terms & Conditions
Hot Products: A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z | 0-9
Copyright Notice @ 2008-2013 ECVERY Limited and/or its subsidiaries and licensors. All rights reserved.