Description:

The alloy powder is made up of Fe-Mn-Si-C-Cr-Ni-B-Ti-W elements and homogeneous mixed by specific formula dedicating to weld, bond and inlay CXD diamond die blanks for diamond wire dies.

It will diffuse lots of high hardness point when utilizing flame and plasma spray molten coating heat source for microalloying, and also has little effect on anti-cracking ability and increase abrasiveresistance.

Technical Data

1. Pressing technique

The pressure and temperature are 300 kg/cm2 650 centigrade. The changing process of heating and pressure. The constant temperature and pressure time should not less than 3 seconds.

2. Technical curve

The Pplat is 300 kg/cm2, the temperature is 650 centigrade. Refer to the following technical curve.

Attention

The appropriate temperature is 650 Celsius degree because it will have negligible damage after the alloy powder solidify in the inlaying process. It is best for using in 2 hours under wet conditions, and the rest should be stored in drying container and used out in one week. It must be repackaged by vacuum packaging for the long time perservation.

Packing

Our alloy powder use vacuum and electrostatics-proof packaging, and the product should stored in a cool and dry environment avoiding damp and using influence. It’s inadvisable to expose in the air.

As a specialized alloy powder supplier based in China, Worldia also provides a wide range of products including diamond engraving tool, PCD saw blade, PCD diamond scribing wheel, and much more.

Alloy powder for diamond wire die