The tube mill is non-standard product and we can design and produce it according to your requirements. The following is some techinical parameters about one type of the mill. For more information, please feel free to contact us.
I. Summary
The mill is intended for manufacturing of round pipe of Φ89mm-Φ219mm with thickness of 2.0mm–6.0mm from cold-rolled and hot-rolled coil strip by means of unclosed tubular blank with its subsequent welding into tube, edge heating by means of solid state high-frequency welder, longitudinal seam welding in rolls of tube welding machine, cooling, further sizing or shaping and on-stream cutting of endless tube in measured lengths.
Finished product will be of round, square or rectangular pipe.
II. Basic conditions:
a) Steel Pipe Specification
1. Round Pipe diameter: Φ89–Φ219mm
Pipe Thickness: 2.0–6.0mm
2. Square & Rectangle Pipe: 70X70–170X170mm 50X90–140X200mm
Pipe Thickness: 2.0 – 5.0mm
3. Pipe Length: 6.0m – 12.0m
4. Length Tolerance: 0-6mm
b) SteelTape Specification
1. Material: Carbon steel (δb≤500Mpa, δs≤235Mpa)
2. Steel Tape:
Inner diameter: Max.Φ510-610mm
Outer diameter: Max.Φ2000mm
Strip steel width: 280-680mm
Strip steel thickness: 2.0-6.0mm
The maximum weight: 10.0 ton
c) Electricity
1. Dynamic power: AC380V±10%, 3phases, 50Hz±1.0%
2. Control Power: AC220V±10%, one phase, 50 Hz ±1.0%
d) Electric installed capacity: appro.900KW
e) Production capacity
Annual output: 80000 ton, according to the yearly working days,daily working hours and the products.
f) Line speed: 30-60m/min
III. The technical flow of the production line
{SteelTape}→→Un-coiler →→Strip-head Cutter and welder→→
Spiral accumulator→→Forming section(Flattening unit +Main driving unit +Forming unit +Guide unit +High frequency induction welding unit +squeeze roller)→→De-burr frame →→Cooling unit →→ Sizing unit and straightener →→Flying saw under computer-control →→ Run-out table
HG219 Erw tube mill