Metallized Polyester Film
FEATURES & USE:
1. Good Printability
2. Good barrier properties
3. Low oxygen permeability
4. High strength
5. No-splash
Technical Standard for VMBOPET Expor
Physical Standard
Properties | Units | Typical Values | Test Methods |
VMBOPET | |||
Tensile Strength MD TD | MPa MPa | ≥210 ≥ 210 | GB13022-91 |
Elongation MD TD | % % | ≤90 ≤90 | GB13022-91 |
Heat Shrinkage MD TD | % % | ≤2.5 ≤1 | GB12027 |
Wetting Tension of Metallized Side | MN/m | ≥42 | GB/T14216 |
Configuration Standard
Properties | Units | Typical Values | Test Methods |
VMBOPET | |||
Thickness | µm | 9-150 | - |
Maximum Width | mm | 2350mm | - |
Thickness Tolerance | % | +/- 3 | GB6672 |
Width Tolerance | mm | +/- 2 | GB6673 |
Thickness of Metallizing Layer | Ohm/Square | 2 | |
Equality Tolerance of Metallizing Layer | % | +/- 5 | |
Combining Fastness Tolerance of Metallizing Layer | % | ≥95 | |
Wrinkle | Strip/m | 0 | - |
Spray Spot | Spot/m2 | ≤2 | |
Lateral Edges Alignment | mm | ≤2 | - |
Splice | Unit/roll | ≤1 | - |
Splice Percent Per Shipment | % | ≤15 | - |
Metallized polyester film