1,Leading manufacturer for plastic injection molding machine; 2,Two color, and rotary table; Technical specification of Two-Component (Rotary Table) Injection Molding Machine

Technical parameter		CMQ168 for wide and flat mould
Injection device		Injection1			Injection2
		A	B	C	A	B	C
Screw Diameter	mm	28	32	36	28	32	36
Screw LD ratio	L/D	24	21	18.7	24	21	18.7
Theoretical capacity	cm3	96	125	156	96	125	156
Injection weight	g	87	114	145	87	114	145
Injection Pressure	MPa	235	180	142	235	180	142
Screw rotational speed	Rpm	0~220			0~220
Clamping device
Clamping force	kN	1680
Moving mould distance	mm	345
Tie bar spacing	mm	700×420
Rotary diameter	mm	760
Max.mould thickness	mm	430
Min. mould thickness	mm	150
Ejector stroke	mm	100
Ejector force	kN	33
Ejector bar amount	PC	2
Mould fixing center to center	mm	420
Others
Max.pump pressure	MPa	16
Pump motor power	kW	18.5
Heating power	kW	5.9
External dimention	mm3	4970×1700×1873
Weight	Kg	8000
Material cylinder capacity	L	25
Oil tank capacity	L	305

Injection molding machine Features:

   The clamping Unit of Two-Component (Rotary Table) Injection Molding Machinetwo sets of hydraulic independent ejector system to expand scope of application and flexibility.   There is a 180°to-and fro rotary drive on the moving platen. It can place two moulds to produce products of two different colors.   Rotate the cooling water connecting device of platen mould. The needed cooling water can be conveniently connected through rotating axis to avoid winding and interference of cooling water pipe.   Both two ejection units adopt new-type single cylinder ejection construction. Ejection and charging operate independently, so several compound ejection can work together.    Fine hydraulic circuit design can reduce the pressure of oil pipes, so the hydraulic control is more accurate.    Two independent proportional pressure & flow control circuits are used to control and drive two sets of injection devices and two sets of hydraulic ejector systems.    The product is molded and formed in one time, therefore, the degree of contraction is reduced to the minimum and the appearance quality is much improved.

Two color Injection Moulding