the specification is as follows :
| Model: TW-2680 | Unit | TW-2680A | TW-2680B | TW-2680C |
Injection set | Screw diameter | mm | 55 | 60 | 64 |
Draw ratio of screw | L/D | 22.9 | 21 | 19.6 | |
Cylinder head volume | cm3 | 569 | 678 | 770 | |
Shot weight | g | 520 | 630 | 710 | |
Injection rate (PS) | g/s | 198 | 232 | 260 | |
Plasticizing rate (PS) | g/s | 73 | 85 | 88 | |
Injection pressure | p | 193 | 162 | 142 | |
Screw speed | m | 180 | |||
Clamping set | Clamp force | KN | 2680 | ||
Max.mould opening stroke | mm | 540 | |||
distance between tie bars | mm*mm | 580*334 | |||
Min.mould thickness | mm | 230 | |||
Max. Mould thickness | mm | 550 | |||
Ejector stroke | mm | 140 | |||
Ejector tonnage | KN | 70 | |||
Ejector number | piece | 9 | |||
General | Rated pressureof oil pump | Mpa | 16 | ||
Pump motor power | KW | 22 | |||
Heating capacity of screw cylinder | KW | 15.6 | |||
Oil tank capacity | L | 550 | |||
Machine weight | T | 8.5 | |||
Machine dimension(L*W*H) | m | 5.70*1.44*2.15 |
plastic injection molding machine