Ads by Google
Nylon board
Processing matters need attention
Because the product is thermoplastic materials, so the user used in processing should pay attention to the following matters
Turning: speed below 600 r/min, feeding speed is less than 0.6 mm/r, and at the same time water or saponification oil cooling.
Drilling: use outside diameter less than or equal to a third of the drilling bar diameter drill (but biggest diameter drill shall not exceed 30 mm), the drill take 90-110 ° Angle and speed of less than 400 r/min, and will roll out in time drill bit, water or saponification oil cooling, continue to the above procedures or reaming holes.
industrial nylon board