1.double heating element with thermostat 2.polishing no-corrosive heating board 3.iron handle 4.teflon moulds

This set contain all the tools you will need to install PPR pipe

heat Element: double heating element with thermostat

Temperature  Range:0-300degree

Welding Diameter :20 25 32  (mm)

Voltage rang:220±25V

Power:1500w  50HZ

welding material:ppr pipe and fitting.

pipe moulds:which is made of Aluminium alloy, and covered with American famous coatings Teflon, to protect the plastic pipes from adhering when welding the pipes,

foot: A special foot  with clamp that enables working at any location

set include:welding machine .clamp foot.cutter.allen key,tape.spirit level.scewdriver.teflon coated die plates.

Using

1 Place the machine on the support. Fix and tight the moulds with the wrench .Please set the smaller moulds in front usually.

2 Turn on power . red indicators show the machine is heating. Red indicator does not shine, the machine has stopped heating. And it is the time for working.

Caution: Do not plug in without ground wire

3 Cut the pipe. Push the pipe and fitting into the moulds for some time (See the table). Pull them out and insert the depth needed steadily .Please do not screw the pipes and fittings

20/32mm pipe welding machine(double heating element)