infalte balloon very easy.Best tool for the party and celebration balloon decoration. Good qulity and competitive price

PICTURES:

  

 

1.IMPORTANT 

*Power supply must be AC 220-240V,50HZ

 

*This pump is intented to balloons.Extended operation over 4 hours can overheat and damage the pump

 

*Keep the pump out of reach of children

 

*Do not obstruct the inflation port&nozzles,keep them ventilated all the time

 

*Choose the suitable nozzle to reduce the working time of pump when inflating the balloons.

 

*MAKE SURE THE OUTLET IS SUITABLE FOR YOU,PLS

 

 

 

2.WARNING

*To reduce the risk,contact qualified electrician to repair or replace the damage cord immediately.

*Carefully following the instructions when inflating the balloons.Never exceed recommended                    pressure,otherwise,serious injury might be caused by the bursting.

*Never leave the pump unattended while the pump is in use.

*Do not keep the pump in wet condition.

*Never allow sand,small rocks,etc,to be sucked into inflation port&nozzles when using the pump.

*Never look inside or point inflation part & nozzles toward your eyes when the pump is working.

*Don't disconnect the pump with wet hands and without to force the supply cord.

*Don't move the pump with aid of supply cord.

*Use the pump only in the described manner.

*If the pump is not used,please turn off.

*Don't use or stop the use if the pump is damaged,especially the supply cord and the case.

*Don't immerse the pump in liquid.

*A periodically maintenance of the pump is necessary.

*The pump don't put down near hot surfaces e.g. hotplate,oven etc.,because the material can smelt.

*The pump should not be impeded by covering the wentiation openings with items,such as newspapers,table-colths,curtains,etc.

 

3.TO INFLATE BALLOONS

*Open the cover of the wire,take out the wire and close the cover(The wire can extend from the hole of the cover),connect plug to 220-240V AC socket.

*Turn the switch on "l",cover the nozzle with the balloon;then press the nozzle slightly inflate the balloons and release to stop.

*For inflating the balloons continuously,pls turn the switch to "ll",then cover the nozzle with balloon to inflate,and turn switch to "o"to  stop.

*For inflating big balloons,cover the balloon on the nozzledirectly;if inflating small or thick material balloons,to screw the small nozzles into the big nozzle t increase the pressure and reduce the time of inflate.

 

Our product is with high quality and competitive price,with advanced machine and handmade,with prompt delivery time and good service.you will get the prompt attention ,so pls feel free to cantact us if you have any questions

electric pump