1. Install the transmitter on a base and then place the transmitter in a suitable position beside an HD video source. 2. The wireless network status indicator is ON after the transmitter power supply is connected and wireless network connection is made successfully. 3. The video status indicator is ON after the transmitter is connected to the video output socket of the HD source with an HD AV cable. * Any video source with the HDMI video output interface can be connected. 4. Connect the IR remote extension connector to the IR remote signal output hole of the transmitter. Installation and Use for Receiver 1. Install the receiver on another base and place the receiver beside an HD display device in another room. 2. The wireless network status indicator is ON after the receiver power supply is connected and wireless network connection is made successfully. 3. Connect the receiver to the HD display device with a standard HD AV cable. The video status indicator on the receiver is ON after video connection is made successfully. Images appear on the display device. * Any display device with the HDMI video input Interface can be connected. 4. The video source can be controlled remotely by pointing the remote control at the IR receiving window on the receiver. Note: This product matches only with an IR remote control in the 38 KHz carrier modulation mode. |