1333 Mhz 1GB Laptop RAM 64 bit 1.Full compatibility Intel 2.Original Chip MT hynix Nanya 3.RMA rate:less than 1%

1GB 128M x 64-Bit PC3 10600 CL9 204 Pin SODIMM Laptop RAM 1GB

DESCRIPTION

This document describes ValueRAM’s 128M x 64-bit (1GB)

DDR3-1333MHz CL9 SDRAM (Synchronous DRAM) memory

module, based on eight 128M x 8-bit DDR3-1333MHz FBGA

components. The SPD is programmed to JEDEC standard

latency 1333MHz timing of 9-9-9 at 1.5V. This 204-pin SODIMM

uses gold contact fingers and requires +1.5V. The electrical

and mechanical specifications are as follows:

FEATURES

    •  JEDEC standard 1.5V ± 0.075V Power Supply

    •  VDDQ = 1.5V ± 0.075V

    •  667MHz fCK for 1333Mb/sec/pin

    •  8 independent internal bank

     •   Programmable CAS Latency: 5,6,7,8,9,10

     •   Posted CAS

     •   Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

     •   Programmable CAS Write Latency(CWL) = 7(DDR3-1333)

     •  8-bit pre-fetch

     •   Burst Length: 8 (Interleave without any limit, sequential with 

         starting address “000” only), 4 with tCCD = 4 which does 

         not allow seamless read or write [either on the fly using A12 

         or MRS]

     •   Bi-directional Differential Data Strobe

     •   Internal(self) calibration : Internal self calibration through ZQ 

         pin (RZQ : 240 ohm ± 1%)

     •   On Die Termination using ODT pin

     •  Average Refresh Period 7.8us at lower than TCASE 85°C, 

         3.9us at 85°C < TCASE ≤ 95°C

     •  Asynchronous Reset

     •   PCB : Height 1.180” (30.00mm), double sided component

1GB 128M x 64-Bit PC3 10600 CL9 204 Pin SODIMM Laptop RAM 1GB