Ads by Google
Features and Benefits
0 Hz ~ 50 MΗz0.1Hz to 100MHz frequency counter10μHz maximum frequency resolution Two channels output independently or synchronouslyWithout limitation for the whole range, digital setting directlyFM, AM, 2FSK, 4FSK, ASK, OSK, 2PSK, 4PSK and burst modulation Data storage and recall.10 groups of generator state parameters can be saved and be recured at any moment if necessary Standard interface of RS-232 and USB device, optional interface of GPIBSpecification
Output Characteristics of Channel A | |||
Waveform Characteristics | Waveform Type | sine, square, pulse, DC | |
Wave Length | 4~16000 points | ||
Waveform Amplitude Resolution | 14 bits | ||
Sample Rate | 400 MSa/s | ||
Sinusoidal Harmonic Rejection | ≥50dBc (≤1MHz), | ||
≥ 40dBc (1MHz~20MHz), | |||
Sine Wave Total Distortion | ≤0.5 % (20Hz ~ 100kHz) | ||
Square rise/fall time | ≤20ns | ||
Frequency Characteristics | Frequency Range | 0Hz~50MHz | |
Frequency Resolution | 100mHz | ||
Frequency Accuracy | ±(5x10-5+ 1000mHz) | ||
Frequency Stability | ±5x10-6/ 3 hours | ||
Pulse Characteristics | Pulse witdh range | 10ns~20s | |
Duty Cycle | 0.1%~ 99.9% | ||
Pulse witdh accuracy | ±(5x10-5+10ns) | ||
Resolution | 5ns | ||
Amplitude Characteristics | Amplitude Range | 2mVpp~20Vpp (high impedance, frequency<40MHz) | |
6Vp-p (High impedance, frequency>40MHz) | |||
Resolution | 20mVp-p (A>2V) | ||
2mVp-p (0.2V<A<2V) | |||
0.2mVp-p (A<0.2V) | |||
Amplitude Accuracy | ±(1%+2 mVrms) (high impedance, virtual value, frequency is 1 kHz) | ||
Amplitude Stability | ±0.5%/ 3 hours | ||
Amplitude Flatness | ±5% (frequency<1MHz), | ||
±10% (frequency between 1MHz~10MHz) | |||
Output Impedance | 50Ω | ||
Modulation characteristics | Amplitude modulation | AM | Modulation signal:interior signal of channel B or exterior signal,depth of modulation:0%~100% |
Amplitude of exterior input signal:2Vp-p(-1V~ +1V) | |||
ASK,OSK | alternative velocity:0.1ms~1000s | ||
Frequency modulation | FM | Modulation signal:interior signal of channel B or exterior signal,maximum offset: 100kHz (carrier frequency>5MHz),Signal of exterior input signal 2Vp-p(-1V~ +1V) | |
FSK | carrier amplitudes and hop amplitudes can be set arbitrarily,alternative velocity:0.1ms~1000s | ||
Types | 2FSK,4FSK | ||
Modulation mode | interior or exterior | ||
Phase modulation | Phase range | 0~360° | |
resolution | 0.1° | ||
alternative velocity | 0.1ms~1000s | ||
Types | 2PSK,4PSK | ||
Modulation mode | interior or exterior | ||
Burst modulation | Burst counting | 1~10000 cycles | |
Interval time of burst signals | 0.1ms~1000s | ||
burst mode | continuous, single | ||
Modulation mode | interior or exterior | ||
Sweep Characteristics | Sweep Range | the start/end point can be set arbitrarily | |
Sweep Step | any value greater than the resolution | ||
Sweep Rate | 10ms~60 s/step | ||
Interval time of Sweeping | 0.1ms~1000s | ||
Sweep Mode | positive, negative, single, to-and-fro | ||
Manual Sweep | step/time | ||
Modulation mode | interior or exterior | ||
Memory property | Memory parameters | the present working state | |
Memory capacity | 10 groups | ||
Output Characteristics of Channel B | |||
Waveform Characteristics | Wave Type | 11 types including sine, square, triangle, ramp, stair and so on. | |
Wave Length | 4096points | ||
Waveform Amplitude Resolution | 10 bits | ||
Frequency Characteristics | Frequency Range | Sine | 10μHz~5MHz |
other waveforms | 10μHz~5MHz | ||
Resolution | 10μHz | ||
Frequency Accuracy | ±(5x10-5 +10μHz) | ||
Synchronous output | |||
Waveform characteristics | sine for both channel A and channel B | ||
Frequency range | <1MHz(when the harmonic time=1) | ||
<150kHz(when the harmonic time>1) | |||
Phase resolution | 0.1 º | ||
TTL Output Characteristics | |||
Waveform Characteristics | square,rise/fall time≤20ns | ||
Frequency Features | same as the output A | ||
Amplitude Characteristics | TTL, CMOS compatible, low level <0.3V, high level >4V | ||
Counter | |||
Frequency measurement range | 0.1Hz~100MHz | ||
Amplitude of input signal | Minimum voltage | 50mVrms(frequency 1Hz~50MHz) | |
100mVrms(frequency 50MHz~100MHz) | |||
150mVrms(frequency 0.1Hz~1Hz) | |||
Maximum voltage | 20Vp-p | ||
Gate time | 10ms~10s adjustable continuously | ||
Maximum counting value | 4.29×109 | ||
Common Characteristics | |||
Display mode | 5.7″TFT color LCD | ||
Dimension and Weight | Chassis Dimensions | 329 mm×283 mm×155 mm | |
Weight | 5.35 kg |
DDS Function Generator,high frequency signal generator,with Frequency counter,50MHz function generator