1. Good flowability 2. Low cost for silicone benefits 3. Room temp or heat accelerated cure 4. 2-part 5. 1:1 mix ratio

Product descriptionQYAE301 silicone encapsulants are supplied as two-part liquid component kits. When liquid componentsare thoroughly mixed, the mixture cures to a flexible elastomer, which is well suited for the protection ofelectrical/electronic applications.

Application• General potting applications• Power supplies• Connectors• Sensors• Industrial controls• Transformers• Amplifiers• High voltage resistor packs• Relays

ProcessingBefore work, keep all the kits clean and dry, without any dust, oily and other material can influence cureand cohere of product. Open the package both A & B part, after pre-mix, supplied in a 1:1 mix ratio.Follow the ratio to mix, deairing & decompression is required, then pour into electronic instrument. Roomtemperature cure encapsulants may also be heat accelerated for faster cure. Pleaes use immediatelyafter opening the package. Airtight storage If residual.

Product data

Before Cure
Appearance	part A		Black
	part B		White
Viscosity	cP	part A	≤6000
	cP	part B	≤6000
Specific Gravity (Uncured Part A&B)	g/cm3		1.7

Curing
Working Time 25C	min		40
Viscosity	cP		≤6000
Heat Cure Time at 80ºC	min		30
Cure Time at 25ºC	hrs		20

After Cure
Specific Gravity	g/cm3		1.7
Durometer Shore A			70
Mechanical property
10% extension of modulus	MPa		0.5
Tensile strength	MPa		4.8
Elongation	%		45
Heat property
Thermal Conductivity	W/mK		≥0.8
flame resistance	can pass UL 94 V-0
Electrical property
Dissipation Factor (tangent)			2×10-3
Breakdown voltage	KV/mm		14
Volume Resistivity	Ω.cm		5.0×1014
Dielectric constant			3

Two-component silicone liquid elastomer