Ads by Google
CY-858-3 gas leak detector
Technical Parameter
| Operating voltage | DC 9V |
| Sensitivity & Time | 50ppm, alarms within 60~90 minutes |
100ppm, alarms within 10~40 minutes | |
300ppm, alarms within 3 minutes | |
| Standby Current: | <10Ua (without LCD); |
| <15uA (with LCD) | |
| Alarm Current | <25mA |
| Operation Ambient Condition: | 5~400C, 20~90%R.H. |
| Size | 12.5*3.5 mm |
Carbon Monoxide Detector(LCD Displayer)IntroductionProduct viewFeatures/SpecificationFeatures:when install the battery on and connect with product,please wait about 3 mins,the sensor is in self-checking-Loud 85 decibel alarm.- Permanent carbon monoxide sensor(NEMOTO).- Powered by 9V batteries.- The alarm sound pattern is four short alarm beeps. The red LED will flash while in alarm mode.once every 30 seconds) or the unit is malfunctioning (green LED is out.).- Alarm memory feature: If the unit ever alarms, pressing the button, red LED will flashes once every second forone minutes and the peak alarm level will indicate on the LCD.- Test/Reset button to test the unit electronics and verifies proper unit operational and reset the unit during COalarm.-Green and red LED lights that indicate normal operation and alarm status.-Yellow LED light that indicate the sensor fault status.indicate it low battery and need replacement. ‘999ppm.” On the LCD to indicate CO level over 999ppm. If the Coleakage is less than 999ppm but over 30ppm, it would show its actual concentration.- Power saving feature: The alarm sound pattern is 4 beeps every 5 seconds for the first 4 minutes. In 4 minutes, itwill change to 4 beeps every minute to save the battery.will sound.The CARBON MONOXIDE (CO) alarm monitors the air for the presence of CO. The alarm will sound and beaccompanied by the flashing red LED light when there are high levels of CO present.CAUTION: This alarm will only indicate the presence of monoxide at the sensor. Carbon monoxide gasmay present at other area.
CY-858-3 gas leak detector