1:Industrial gas detector 2:Imported sensor 3:Four BUS communication 4:Built-in imported DIP switch 5:Detecting toxic

Industrial Gas Detector

Our this gas detector can detect all kinds of toxic gas.When gas concentration reach calibrated valve, this detector may send out signal to gas monitoring system.And gas monitor may do some protective action according to program.

 Feature:

1.Adopts imported sensor with high measurement accuracy, high stability, strong anti-poisoning and anti-interference ability.

2.Automatic recognition and protection the concentration of sensors , short-circuit and open-circuit of sensors, and automatic fault detection .

3. Built-in imported Dial Switches, you will get what you want when you dial, this can avoid the confusion of physical and logical address caused by Electronic digit block string number.  

4. Explosion-proof design, it is suitable for II gas environment

5. Adopts HBUS four buses communication mode ,power wire and signal wire both use non-polarity design.And with automatic protection function to avoid damaging controller caused by short -circuits in the use.

6. Intelligent sensor, replace sensor without demarcating.

7.Pipe-mounted and wall-mounted optional.

 Technical:

Model No.	XP2000	Power consumption	≤1.5W(DC24V)
Detection principle	Catalytic  / Electrochemical /Infrared/PID	Gas Sample mode	Natural diffusion
Communication mode	four hbus	Working voltage	DC14V~35V( detector terminal)
Install screw thread	G 3/4" internal thread	Dimension	70mm×96mm×170mm
Explosion-proof sign	ExdIICT6	Protection class	IP65
Detection Gas	Combustible gas,  VOC (Certain Organic Vapors), H2(ppm), CO,H2S,O2(VOL),NH3 ppm),Cl2,NO,SO2	Working condition	temperature:-40°C~+70°C(Catalytic); -20°C~+50°C(Electrochemical),-20°C~+55°C(PID),-40°C~+70°C(Infrared) humidity:10%~93%RH(incondensable);  pressure range:86~106kPa

Industrial gas detector for toxic gas