Ads by Google
Rubber traffic speed bump
Specification:
| Item No. | rubber speed hump |
| Material | rubber |
| Size | 50*90*5cm(middle section);27*90*5cm(end section) |
| Reflector | 6pcs,11*25cm |
| Package | woven bag |
Features:
1. Rubber Road Traffic Speed Hump (speed hump, road hump, speed breaker, sleeping policeman,) is a speed-reducing feature of road design to slow traffic or reduce through traffic.
2. Our speed hump is a bump in a roadway with heights typically ranging between 2and 3 inches. The length of road bumps are typically less than or near to 1 foot (30 cm);
3. whereas road humps are longer and are typically 10 to 14 feet (3.0 to 4.3 m) in length.The use of speed bumps is widespread around the world, and they are most commonly found where vehicle speeds are mandated to be low. Because speed bumps are very effective in keeping vehicle speed down,Advantages of speed hump:
4. They are relatively inexpensiveThey are relatively easy for bicycles to cross if designed appropriatelyThey are very effective in slowing travel speeds.
5. Rubber Road Traffic Speed Hump are good for locations where very low speeds are desired and reasonable, and noise and fumes are not a major concern.
6. Usage:* Mainly used for city intersection, highroad crossing, toll gate,garden, village, parking lot, and gas station, etc.
7. fixer for asphalt roads : expansive screw (standard parts, the customercan easily purchase on local market);
8. To improve life span, the road must be smooth. After drilling, cleanUp the holes and remove the dust, oil and debris from the holes.Using the special adhesive, put the bottom of the bump to the surface of the road
9. Speed bumps can be installed on the surface of asphalt roads and concrete roads
10. For A type road bumps, use a steel bar or PVC pipe to link them up from the middle
11. The fixer and the hole must be matched in size For more information about this Rubber Road Traffic Speed Hump,please feel free to contact us.
Steps to install the speed humps:
Step 1: To gurantee the life span of the speed hump, workers should smooth the road first before fixing.
Step 2: Put the speed humps in a straight line.
Step 3: Drill through the holes of the speed humps into the ground until 12cm deep.
Step 4: clean up the holes and remove the dust, oil and debris from the holes.
Step 5: Knock the screws through the holes until the screws expand completely to make the speed humps firmly installed.
ANOTHER TEMPORARY ITEM AS BELOW
reflective rubber road speed bump in black