1)stepping motor driver 2)Low noise 2-phase stepping Driver; 3)input:20--40v, 4)output:1.0--4.2A; 5)Microstep:4--256;10--250

 Description of   stepping motor driver

PSD5042-2P/2-phase stepping driver Key Features: 

  20 to 50VDC Supply Voltage   H-Bridge, 2 Phase Bi-polar Micro-stepping Drive   Suitable for 2-phase, 4, 6 and 8 leads step motors, with Nema size 16 to 34   Output current selectable from 1.0 ~ 4.2A peak   Current reduction by 50% automatically, when motor standstill mode is enabled   Pulse Input frequency up to 200 kHz   Optically isolated  differential TTL inputs for Pulse, Direction and Enable  signal inputs   Selectable resolutions up to 25000   steps    Over Voltage, Coil to Coil and Coil to Ground short circuit protection.

Introduction

PSD5042-2P  is a cost effective, high performance bi-polar two phase micro-stepping drive applying pure-sinusoidal current control technique.  It is best suited for the applications that desired extreme low noise and heat. It operates well in an environment, where electricity supply experience instability and fluctuation .

The general pseudo-sinusoidal current control technology adopted by majority of the drive produced distorted sine wave, and current ripple, resulting in vibration, noise and motor heating.  This results in motor degrading over time, reducing in motor performance and shortens the usage life.

With an automatic optimization speed control technique, the PowerStep series drive output is very stable, with almost zero vibration and noise, performing close to a servo system,  allowing the motor to operate smoothly. That helps to fulfill a design requirement of low noise, low heat and high performance.

Specifications

Parameters	Min	Typical	Max	Unit
Output Current (Peak)	1.0	-	4.2	Amps
Supply voltage	20	36	50	VDC
Logic Input Current	7	10	16	mA
Pulse input frequency	0	-	200	KHz
Low Level Time	2.5			µsec

Current Setting

Current Setting (A)	SW1	SW2	SW3
1.0	ON	ON	ON
1.46	OFF	ON	ON
1.91	ON	OFF	ON
2.37	OFF	OFF	ON
2.84	ON	ON	OFF
3.31	OFF	ON	OFF
3.76	ON	OFF	OFF
4.20	OFF	OFF	OFF

Microstep  Setting

Step / Rev	SW5	SW6	SW7	SW8
400	OFF	ON	ON	ON
800	ON	OFF	ON	ON
1600	OFF	OFF	ON	ON
3200	ON	ON	OFF	ON
6400	OFF	ON	OFF	ON
12800	ON	OFF	OFF	ON
25600	OFF	OFF	OFF	ON
1000	ON	ON	ON	OFF
2000	OFF	ON	ON	OFF
4000	ON	OFF	ON	OFF
5000	OFF	OFF	ON	OFF
8000	ON	ON	OFF	OFF
10000	OFF	ON	OFF	OFF
20000	ON	OFF	OFF	OFF
25000	OFF	OFF	OFF	OFF

* SW4: ON=Full current, SW4 : OFF=Half current

2-phase stepping motor driver