Air Bag Suspension 1.SGS and ISO certified. 2.Firestone, Contitect, Goodyear, Pirelli etc. 3.Material:Rubber& Metall

Air Bag Suspension

We are the leading suppliers of high quality air spring system to the transport industry, having particular emphasis on cost effective engineering, design and test, manufacture and supply of truck and trailer air suspension, lift axle suspensions and components to suit the OEM manufactures in our region. The production technique is considered the best in China, and our products are considered the standard by the Ministry of Light Industry Ministry.

Products

H series Air spring: BELLOWS : Wall gauge is approximately 5 mm. GIRDLE HOOP: Wire wound type shown, molded into the bellows.BEAD RING: upper and lower. countersunk steel type shown. May also be of a second stamped steel variety or made of aluminum.AIR INLET:  1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts.BOLT: M10 x 45 mm Used for mounting the part. MOUNTING PLATE:  The plates must be strong enough and backed by structural members to prevent bowing of the forces or loads involved

 

J series Air spring:BLIND NUT:  M8 x 15 (two or four per each plate depending on part size). Used for mounting the part. MOUNTING PLATE:  The plates must be strong enough and backed by structural members to prevent bowing (of the forces or loads involvedAIR INLET:  1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts

K series Air spring:BLIND NUT:  M8 x 15 (two or four per each plate depending on part size). Used for mounting the part. MOUNTING PLATE:  The plates must be strong enough and backed by structural members to prevent bowing (of the forces or loads involved.AIR INLET:  1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts.

ZF series Air springBLIND NUT:  M8 x 15 (two or four per each plate depending on part size). Used for mounting the part. MOUNTING PLATE:  The plates must be strong enough and backed by structural members to prevent bowing (of the forces or loads involved. AIR INLET:  1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts.

CY series Air springBLIND NUT: M8 x 15 (two or four per each plate depending on part size). Used for mounting the part. AIR INLET: 1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts.

We can make products according to your requests and  provide OEM service as well as one-stop service.

 Your inquiry will be highly appreciated!

Air Bag Suspension