Wall Type Automatic Timer Switch
Specification
Movement type | AC type | |||
Rated voltage | 110V AC | 220V AC | ||
Voltage tolerance | 85~120V | 170V~240V | ||
Frequency | 50Hz/60Hz (common use) | |||
Mounting Stype | Flush Mounting | |||
Manual ON/OFF | ON/AUTO/OFF switch | |||
Ambient temperature | -10~+50 | |||
Resistive load | 250V AC 15A | |||
Lamp load | 10A | |||
Inductive load | 12A (cos Φ=0.7 or more) | |||
Moter load | 110V AC 750W,220V AC 1500W | |||
Minimum setting unit | 15 minutes/ unit | |||
Minimum setting interval | 15 minutes | |||
No. of ON/OFF operations | 96 operations | |||
Weight | 190g | |||
Dimensions | 71.5x43x71.5mm |
TIMER SWITCH PARTS IDETIFICATION
DIMENSIONS OF THE TIMER SWITCH
TIMER SWITCH INSTALLATION
Before installing,check that this unit conform to the operating voltage
Adjust the frequency selector knob to the adequate frequency.
Do not install this unit in a place as described in the "cautions 3 paragraph".
1.hook the mounting hole (rounding-bellied hole) at the rear case on a wooden screw, and secure the two lower mounting holes(round), using wooden screws.
2.to connect an electric wire, break a vinyl chloride bushing and open the terminal cover.
WIRING CONNENECTION DIAGRAM:
when the time switch is used for loads exceeding the rated capacity. It is imperative that the time switch be used in combination with one or more magnetic cont-actors according to each lcad.
wall type automatic timer switch