Truck Air Bag Suspension
H series Air spring: BELLOWS : Wall gauge is approximately 5 mm. GIRDLE HOOP: Wire wound type shown, molded into the bellows.BEAD RING: upper and lower. countersunk steel type shown. May also be of a second stamped steel variety or made of aluminum.AIR INLET: 1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts.BOLT: M10 x 45 mm Used for mounting the part. MOUNTING PLATE: The plates must be strong enough and backed by structural members to prevent bowing of the forces or loads involved
K series Air spring:BLIND NUT: M8 x 15 (two or four per each plate depending on part size). Used for mounting the part. MOUNTING PLATE: The plates must be strong enough and backed by structural members to prevent bowing (of the forces or loads involved.AIR INLET: 1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts.
ZF series Air springBLIND NUT: M8 x 15 (two or four per each plate depending on part size). Used for mounting the part. MOUNTING PLATE: The plates must be strong enough and backed by structural members to prevent bowing (of the forces or loads involved. AIR INLET: 1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts.
CY series Air springBLIND NUT: M8 x 15 (two or four per each plate depending on part size). Used for mounting the part. AIR INLET: 1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts.
Your friendly enquiry would be highly appreciated.
Truck Air Bag Suspension