Ads by Google
KEY FEATURES:
Online double conversion VFI provide pure sine ware UPS power source.IGBT inverter and output isolation transformer improve the system efficiency and reliability for kinds of load: transformer, emergency light, electric facility, industry processes, etc.Parallel redundant, parallel up to 8 modules.Detect all the information and status showing on LCD.Intelligent RS232 Communication Port.Set output voltage from 220~240V.Over voltage, low voltage, over current, over load, etc can be detected and supply reliable protection. (EN/IEC60240).Advanced battery management.UPS monitoring software.Technical Parameters:
| Model | HP10000 | |
| Capacity | 100KVA | |
| Output power factor | 100~70% | |
| Efficiency(normal operating), load 100% | 93~95% | |
| Efficiency(economic model ), load 100% | 98% | |
| Maximum leakage(mA) | 100 | |
| Mean time between failures(MTBF) | 200,000 hours | |
| Remote signaling | 3 dry contact (battery low, battery discharge, bypass/failure);output 12Vdc 80mA | |
| Remote control | EPO, bypass. | |
| Communication | RS232/C | |
| Operating temperature | 0±40°C | |
| Max relative humidity | 95%(non condensation) | |
| Cool down | Mandatory wind( RPM change according to load.) | |
| Altitude | 1KM output normal power( with increase of 100m, reduce 1%) Max 4KM | |
| Noise | 60~65 dB | |
| Protecting Standard(EN 60529) | IP20 | |
| Incoming/outgoing cables | Downward/Back | |
| Standard | Standard:GB4943; Battery combinations:GB7260.2, GB/T 17626.2~5 | |
| Dimensions(W*D*H)mm | 1200*740*1400 | |
| Weight(without battery)KG | 900 | |
| Rectifier input(standard UPS) | ||
| Rated voltage | 380V,3 phases | |
| Voltage range | ±20% | |
| Rated frequency | 50/60Hz auto sensing | |
| Frequency range | 45~65 | |
| Maximum input current[A] | 175 | |
| Power Factor | 80% | |
| Soft start | 0-100%,10 seconds | |
| Battery | ||
| Charge current setting | 0.5A*C10 | |
| Units(Rated voltage ) | 216(432VDC) | |
| Charge current setting | 0.2A*C10 | |
| Inverter output | ||
| Rated voltage[v] | 380(3 phase+N) | |
| Rated current[A] | 148 | |
| Phase voltage | 200~244V(control pannel) | |
| Waveform | Sine wave | |
| (Ipeak/Lrms) | ||
| Linear load wave distortion | <2% | |
| Nonlinear load wave distortion | <5% | |
| Voltage Stability | ±1% | |
| Transient voltage stability | ±5%(in 10ms) | |
| Rated Frequency | Same as input frequency. | |
| Overload | 600'/10'/1', (110/125/150% at nominal current.) | |
| Inverter Efficiency | 96% | |
| Bypass | ||
| Rated Voltage | 380 (3 phase +N) | |
| Input voltage range | ±15% (Settled to ±10% or ±25% via control panel available.) | |
| Rated Frequency | 50Hz/60Hz | |
| Frequency range | ±2% (Settled to ±5% via control panel available.) | |
| Inverter/bypass transfer time | <1ms | |
| Overload capacity | 10"/1"/18"(150/175/200% at nominal current.) | |
Online three phase UPS power source(100KVA)