Ads by Google
High Efficient Best Selling Feed Pellet Making Machine
Use of Pellets
The pellets can be used in different areas, such as animal feeding, heating of the buildings, and the production of the manure. The major advantage of the pellets compared with other material, it can be easily handled, transported and stored for longer life.
Fundamental to the starting pellet
Pellets can be produced from various organic materials. Thus, the starting material bonds to be fixed into durable pellets, and the moisture contents need to be controlled within 12% und 15%. If the starting material is too dry, it often occurs as powder or need to be re-emerged from the
pellet chute. If the starting material is too damp, the pellets will be of inferior quality. The
residual moisture of the starting material can be measured or determined by a commercial
moisture meter. The length of raw material should be controlled within 5mm, otherwise the pellet mill machine will be clogged or the performance will be slowing down. The raw material with longer length (e.g. wood shaving) need to be grinded into small size by a hammer mill.
Pellet-Types
Here are the main types of pellets and the composition of starting material which can be used
for pellet.
Saw Dust Pellets
Starting material: Saw dust
Use: Pellet Heating
Mixture:a. Pine or spruce percentage at least 50%: It can be directly pressed into pellets.
b. Portion of pine or spruce less than 50%: For stable pellet it needs to add 0.2-2% corn or patato starch. (Total moisture content 12-15%)
Straw-Pellets, Hay-Pellets, Miscanthus-Pellets
Starting material: Straw, Hay, Miscanthus (chopped)
Use:Pellet-Heating, Animal Bedding,Feed
Mixture: directly (Moisture 12-15%)
Feed-Pellets
Starting material:Straw,Hay,other feed (chopping)
Use: Animal Bedding,Feed
Mixture: directly (Total Moisture Content 12-15%)
GREASE
Be lubricated after each use or after 8 hours operation.
Grease nipple for die
Grease nipple for gear
EXCHANGING MATRIX
01–Disconnect the power connector
02–Remove the funnel
03–Loosen the lock nuts and open the screws for the tension roller
04–Remove the four screws for the case in which the matrix is fitted
05–Lift the roller from the case carefully
06–Clean the roller and case housing
07–Remove the retaining pin
08–Remove the retaining nut with tool provided
09–Under the shield are the holes for the puller
10–Place the puller to die and remove it carefully
11–Thoroughly clean the die
12–Set the machine back together in reverse order
High Efficient Best Selling Feed Pellet Making Machine