pellet mill With the fast development of Wood Pellets industry, wood pellet machine becomes very popular in the world

Efficient centrifugal pellet mill

Performance and the difference between similar productsI.Seven characteristics1.Vertical feeding directly in place.2. Die static, roller rotating, materials centrifugal, Evenly distributed around.3.Double-layer dies, up and down dual-use, reduce the cost,enhance the efficiency, can be dual-use,high capacity,energy saving.4.One die,different hole diameters, with different specifications to pelletize.5.Macroporous die, wire joining circular tube, increasing travel, improving density.6.Ring die,vertical structure,good for cooling the pelletizing room.7. Independent and frequency conversion discharge device, to ensure that the rate of pellet formation. II.Four differences1.Upward mould, special structure,vertically feeding,easier heat dissipation: the material is feeded into the pelletizing room vertically and is well placed, no other pressing device is needed. The feed inlet of ring die pellet mill is set in one side, so light material is hard to get into the pelletizing room and other special force pressing device is needed, what’s more important, the lifetime of gearing(gear, bearing) is shorten as the pelletzing room couldn’t dissipate the heat and be cooled. Flat die pellet mill has two structures, but both have many disadvantages that are hard to get rid of even they can be feeded vertically. (1) die rotates to make rollers run, the output will be effected as material is easily arched which lead to uneven feeding. (2) When the rollers rotate while the die is static, which could avoid the arching of material, but centrifugal force is caused which will swing the material in the pelletizing room to the periphery. And that will cause the upward flat die with evenly distributing pellet holes in it has no material to press in the center, then material piles up unevenly in thickness.2. Die static, roller rotating, material centrifugal and distributed around evenly: using a unique double-layer high rebounding-effect die,naturally and evenly distribute in the die’s inner surface.Normally ring-die pellet mill’s rollers are static, die rotates, no centrifugal force,unevenly distributed material.Normally flat-die pellet mill’s rollers rotate to generate centrifugal force, but the die hole is inconsistencies with the material force.  3. Double-layer dies, multi-function, high efficiency: die has upper parts and lower parts, can choose two different specifications of aperture, to produce two different specifications of pellet. When pelletizing good bonding materials, can heighten the rollers and two-layer dies to reach four-fold capacity. No flat die, ring die can do this.4. Macroporous die, wire joining circular tube, increasing travel, improving density.Because when briquette machine operating the die is static, then pelletizing large-diameter briquette, can die aperture outside wire joining circular tube, increasing travel, small size, low-cost die,can also enhancing the finished product’s density (density of finished briquette can be changed through adjusting the length of circular tube). Normally ring die pellet mill’s die is rotating,can not wire joining circular tube, to pelletize the large diameter briquette,can not reduce die’s cost. Flat die pellet mill can not be incomparable.

animal feed pellet mill