Product features
It will produce phenomenon such as micro-expansion, low shrinkage and slight vibration during the hardening process. It can be construction by drying filling, tamping surface, scrape, dump and pumping. It has high strength and long durability in the early period. It has fast hardening that the time is less than 7 hours. It is not contain metallic materials which could cause rust. It is not contain chloride that could avoid the corrosion to the steel and bolt. It is precast in factory that could be used by adding water. The compressive strength is up to more than 60Mpa.
Scope of application
It is suitable for flow type grouting materials, precast or pre-casting folder and the grouting of the column.
It can be used to fill the holes and defects of concrete and joint cracks between the blocks. As well as concrete joint, cable car track and mechanical support, etc.
It is used for the secondary grouting of the installation of steel column and equipment.
It can be used for anchor bolts grouting, slab grouting, concrete hollow of concrete precast installation and repair grouting of crack defects.
It is suitable for the paste grouting of large stone and tile walls.
The toughening type is suitable for installation of large general equipment with strong vibration, basic secondary grouting (large ore crusher, large-scale ball mill, heavy hammer, cold rolling mill, conveyors, power transmission tower, bridge bearings, steam turbine generator sets, large paper machine, crane track and gantry crane rails, etc.)
Treatment of base plane
It should be clean, strong, and free of grease, dust, powder and other loose materials.
Bolts and nuts should be cleaned.
The concrete base materials should be pre-wet but without clear water before construction.
Construction technology
Stir with enough water using the high-speed electric stirrer for 5 minutes.
Construction
The product should be used with 30 minutes after stirring in general temperature.
The thickness of non-shrinkage grouting should be between 20 and 150mm. Prohibit to increase mobility by the mechanical vibration which could avoid the segregation phenomenon.
Maintains
The exposed parts should be covered by wet cloth or plastic film after the construction to prevent excessive evaporation.
Storage period
Keep in cold and dry place, unopened product is valid for 1 year.
Spec.
25kg/bag
Technical parameters
Compressive strength (28d, MPa) | ≥ 60 | |
Effluence rate (%) | ≤ 0.5 | |
Fluidity (mm) | ≥ 250 | |
Shrinkage | -0.15-0.15 (h) | |
Setting time (h) | Initial setting | ≥ 1 |
Final setting | ≤ 10 |
Non shrink grout