Waste tyre&plastic recycling plant 1.Professional manufacture 2.ISO14001:2004 ,ISO9001:2008 and CE 3.Strict quality control

Raw materials can be used:

1. Waste/Used rubber tire

2. Waste industrial mixed plastics, and allow multi-kind flotsams exist at the same time, but PET is an exception.

3. Waste oil: For instance : waste diesel oil, engine oil, and other residue oil.

4. Waste cable skin (first dechlorination treatment will be suggested)     

5. Waste crude oil and so on.   

6. Regeneration of waste PMMA (polymethyl methacrylate)

The products getting after pyrolysis operation are as follows:

1.Crude oil : 40%~ 45%( Because the oil production depends on the quality of the tyre and usually it's between 40%~45%)

2.Steel wire : 13%

3. Carbon black:37% (can be used to make briquette )

4. Waste water and steam:5%~10%

 

Working process

First, the raw materials are put into the furnace, then seal the feed inlet then the bottom of the reactor will slowly heat the wastes by coal or electricity. When the temperature reaches the degree of 250 to 280, we will get the crude oil, the oil steam will be continuous produced until the temperature reaches 300-400°C; oil steam will flow through light and heavy components separating device; light component will enter the condenser and meanwhile the residues will be discharged automatically in succession. But the liquefied part will be condensed to rubber oil, and the part that cannot be liquefied will be input into heating supply system for burning by way of combustion gas purification system.

waste tyre refining equipment