2.Specification:
Model No. | PIR-505A&B Extended-In Light Sensor |
Power Supply | AC100~240V 50/60HZ |
Max. Load | Incandescent lamp: 60W , Energy saving lamp: 23W |
Power Consumption | standby: <1.3 W |
Sensing Angle | R&L:< 130°, Up & Down: < 90°(at 25°C) |
Sensing Distance | 25° C <8m |
Illumination | Under 3LUX: sensor is active , over 30LUX: sensor not active |
Off Delay time | Short time:10 sec.(night) Mid. time:90 sec.(night) Long time:330 sec.(night) |
Warm-up Procedure | Install at daytime: the lamp will flash 3 times after energized. Install at nighttime: the lamp will light for about 20 seconds then automatically shut off after energized. |
Dimension | 6×6×7.5cm |
Weight | 85g |
Wiring | Rotating socket |
3.Instructions:
Turn off the power source, and take off original screw bulb into PIR-505A&B.Finally, install them into the lamp holder and turn on the power source.A Type: It has the"day & light" function because it has CDS (when the daylight is over 30 lux value, the lamp will be off )B Type: It has no "day & night" function. The lamp always light up when people arrive no matter day or night.Install at daytime: the lamp will flash 3 times after energized.Install at nighttime: the lamp will light for about 20 seconds then automatically shut off after energized.Short time:10 sec. (night), Mid. time:90 sec.(night), Long time:330 sec.(night)human body light infrared motion sensor switch Lamp holder