Ads by Google
100W Triple Output Switching Power Supply
AC input range selected by switchProtections: Short circuit/Over load/Over voltage100% full load burn-in testFixed switching frequency at 25KHz
5V | 15V | -15V | 5V | 12V | -24V | |
10A | 2.5A | 1A | 6A | 2A | 2A | |
2-12A | 0.2-2.5A | 0.1-1A | 2-12A | 0.1-2A | 0.2-2A | |
100W | 102W | |||||
80mVp-p | 150mVp-p | 150mVp-p | 80mVp-p | 1500mVp-p | 150mVp-p | |
CH1: 4.75 ~ 5.5V | CH1: 4.75 ~ 5.5V | |||||
±2% | ±6% | ±6% | ±2% | ±6% | ±6% | |
±0.5% | ±1% | ±1% | ±0.5% | ±1% | ±1% | |
±1% | ±5% | ±5% | ±1% | ±5% | ±5% | |
200ms,50ms,16ms | ||||||
85 ~ 132VAC / 170 ~ 264VAC selected by switch 240 ~ 370VDC | ||||||
47 ~ 63Hz | ||||||
77% | 79% | |||||
2.5A/115VAC 1.25A/230VAC | ||||||
COLD START 30A/115VAC 60A/230VAC | ||||||
<0.5mA / 240VAC | ||||||
105 ~ 150% rated output power. | ||||||
Protection type: Fold back current limiting, recovers automatically after fault condition is removed. | ||||||
-10 ~ +60ºC (Refer to output load derating curve) | ||||||
20 ~ 90% RH non-condensing | ||||||
-20 ~ +85ºC, 10 ~ 95% RH | ||||||
±0.03%/ ºC(0 ~ 50ºC) | ||||||
10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes | ||||||
Design refer to UL1012 | ||||||
I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC | ||||||
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC | ||||||
463.1K hrs min. MIL-HDBK-217F (25ºC) | ||||||
199*110*50mm(L*W*H) | ||||||
0.795Kg; 16pcs/14.27Kg/0.0287CMB | ||||||
1.All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25ºC of ambient temperature.2.Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.3.Tolerance: includes set up tolerance, line regulation and load regulation. |
100W Triple Output Switching Power Supply